A. leakage reactance
B. per unit impedance
C. efficiencies
D. ratings

Advertisement

Related Mcqs:

  1. Two transformers are connected in parallel. These transformers do not have equal percentage impedance. This is likely to result in____________?
    A. short-circuiting of the secondaries B. power factor of one of the transformers is leading while that of the other lagging C. transformers having higher copper losses will have negligible core losses D. loading of the transformers not in proportion to their kVA ratings...
  2. What will happen if the transformers working in parallel are not connected with regard to polarity ?
    A. The power factor of the two trans-formers will be different from the power factor of common load B. Incorrect polarity will result in dead short circuit C. The transformers will not share load in proportion to their kVA ratings D. none of the above...
  3. If the percentage impedances of the two transformers working in parallel are different, then______________________?
    A. transformers will be overheated B. power factors of both the transformers will be same C. parallel operation will be not possible D. parallel operation will still be possible, but the power factors at which the two transformers operate will be different from the power factor of the common load...
  4. For the parallel operation of single phase transformers it is necessary that they should have___________?
    A. same efficiency B. same polarity C. same kVA rating D. same number of turns on the secondary side....
  5. The efficiency of two identical transformers under load conditions can be determined by_______________?
    A. short-circuit test B. back-to-back test C. open circuit test D. any of the above...
  6. Power transformers are designed to have maximum efficiency at___________?
    A. nearly full load B. 70% full load C. 50% full load D. no load...
  7. Power transformers are generally designed to have maximum efficiency around__________?
    A. no-load B. half-load C. near full-load D. 10% overload...
  8. Star/star transformers work satisfactorily when________________?
    A. load is unbalanced only B. load is balanced only C. on balanced as well as unbalanced loads D. none of the above...
  9. Open circuit test on transformers is conducted to determine____________?
    A. hysteresis losses B. copper losses C. core losses D. eddy current losses...
  10. The efficiencies of transformers compared with that of electric motors of the same power are____________?
    A. about the same B. much smaller C. much higher D. somewhat smaller E. none of the above...
Advertisement